1} Press Menu on your STB Remote Control and choose SETUP {1}
2} Then select CrossEPG {2}
Continue Reading..
Tag: usb
1} Press the Blue button twice @STB Remote Control, you will then see this menu{1}
2}Then Select Usb Format Wizard, press the Red button and then press Red again. You see info about connecting your USB stick [you will see step by step info, telling you what to do] {2}
Continue Reading..
How to setup a SWAP file using a USB stick
As follows :-
1} Press Blue button @STB Remote Control and then again press the Blue button, the info page will show you
Please remember to run Meoboot you must have the Black Hole image in the flash memory of your box.
As follows :-
1} Press Green button @STB Remote Control and select from the plugins Meoboot, the plugins page will look like this
How to setup Universes in BH image
As follow:-
1} To run/setup universes in BH image you must have mounted your usb to /universe because all the universe worlds are saved on your usb stick. The best way to do this is to make 2-3 partitions on your usb using the usb format wizard from the Blue panel, and mount 1 of the partitions as /universe. You can mount 1 of the other partions ase /media/usb (or whatever else you want to mount as) {1}
How to setup your Vu+ box for recording on an usb stick or on another device connected to an usb port.
Mount your usb stick by Devices Manager as /media/usb
Blue Panel > Black Hole Settings > Devices Manager > Mountpoints …
How to Mount USB in the Black Hole Devices Manger
As follows :-
1} Press Blue button twice @STB Remote Control and select the Devices Manger, you will see this screen {1}
To use MeoBoot, obviously, you need to install a devices (HDD or USB Stick), to format it in EXT4 and to mount it.
You can format and mount the device by Black Hole Devices Manager.
After installing your device, you have to enable MoBoot by opening it by Black Hole Green Panel and choosing your preferred device to use for multiboot.
In this tutorial I am going to show you how to put picons onto usb stick. This is 1 of a few ways of doing this and for me this is easier than unplugging usb plugging back in etc lol
For this you need a usb stick formatted as fat32 or ext3 and the usb to be mounted correctly in device manager as media/usb
You can check if this is the case by going to Menu/Setup/ViX/Devices Manager and should look like this below;
Necesary a USB Pendrive in FAT32 o Ext Format.
Insert pendrive in any USB slot receiver
In remote control press blue Button and again blue
Again screen
In remote control press Red button Mounpoints
