Tag: install

How to install Oscam on 4K receiver!

In this tutorial I’m gonna tell you how to install Oscam on your 4K receiver.
Continue Reading..

How To Load Or Setup CCcam Card Sharing On Skybox/Openbox S9 Using Remote Control

CLINE SETUP

1: Go into the main menu
2: Select Network, enable your network and set the IP address to DHCP. Go back to network.
3: Select “CCcam Client Setup” If you can not see CCcam setup in the menu jump to number 9
4: If you have a cccam.cfg on your usb, we provide the CCcam.cfg file, ask for the full configured file from us to get all of our channels. Copy the CCcam.cfg file into the root folder from your USB stick. Do not copy the file in a specific folder.Select ‘Update files by usb’ if not, jump to number 10

Continue Reading..

How to install tar.gz files from Black Hole image

Basic Note: for we install tar.gz files in Black Hole image we need rename file from tar.gz to bh.tgz

for my tutorial i will use Ipkg_Builder_bh.tgz

with my favorite ftp program i send file to tmp folder in my receiver after i’m going to remote control
and we press green/yellow button and we follow fotos step by step after any foto we press ok

screenshot.jpg Continue Reading..

How to install new Drivers on VU+

Here is a little guide to install new VuPlus drivers.
FOR OLD KERNEL
First of all make a backup copy of the current drivers, copy all the files in
/lib/modules/2.6.18-7.3/extra
When new drivers comes out, take tar.gz drivers file and unzip all files in
/lib/modules/2.6.18-7.3/extra
and replace old drivers.
Than reboot your decoder, that’s all.
If image reboots correctly new drivers are compatible with your image, if image doesn’t start it means that the drivers are not compatible and you have to wait for a image upgrade.
In this case to go back to old drivers, just connect with ftp and copy the drivers you backup before to:
/lib/modules/2.6.18-7.3/extra

Continue Reading..

How to install .ipk files from Black Hole image

First we send ipk file with VUcc to tmp folder in our receiver
after we are going green/yellow button and after
here is photos step by step

[IMG]Continue Reading..

How install an image on a USB stick with Meoboot

Please remember to run Meoboot you must have the Black Hole image in the flash memory of your box.

As follows :-

1} Press Green button @STB Remote Control and select from the plugins Meoboot, the plugins page will look like this

1.JPGContinue Reading..